|
|
Effective Fast: Carbondioxide is a three-dimensional clean agent.
Within seconds, it penetrates the entire hazard area to smother the
combustion.
Efficient: CO2 vapor chokes off combustion quickly. The dry ice
“snow” in the discharge allows “local application” protection of non-nclosed
hazards.
A Low-Cost Clean Agent: CO2 is colorless and odorless. It exists
as a gas in the earth’s atmosphere and is one of the by-products of
combustion. It use has no environmental effect.
Non-damaging: CO2 is normally harmless to equipment, materials and
property. It does not cause spoilage, requires no clean-up and leaves
no residue, thus minimizing downtown after a fire. |
|
 |
|
|
Non-conductive: CO2 is
elektrically non-conductiveand three-dimensional, allowing use for
a wide variety of special applications.
Adaptive: CO2 is effective on a wide range of flammable and
combustible materials in both surface and deep-seated fires.
Recognized: By the top independent listing and approval
agencies.
Multiple Hazard Versatility: Multiple hazards may be protected
from a common supply of CO2 by using pneumatically operated
directional (selector) valves. |
| |
|
CO2 Chemical and Physical Properties
CO2 is an odorless, colorless, inert gas that extinguishes
fire primarily by diluting the oxygen that supports combustion.
Some cooling is also accompolished. It is used as an active
free extinguishant and applied by either the total flood or
local application method. In flooding, the enclosure of the
hazard protected is flooded to a proper concentration.
In the design concentrations required to extinguish fire, CO2
will not support human life. |
 |
| |
|
 |
Because CO2 is 1.5 times heavier than air, it will tend to
settle in low-lying areas in the protected hazard as well as
flow into adjacent areas outside of the protected space.
In local applications, CO2 is directly applied in the proper
amount at the needed rate to cover the protected hazard. The
small “dry ice” particles, created
in the discharge, facilitate its protection into the fire and
coverage of the hazard protected. |
|
|
|
Application
Areas
- Power Generation
Base Load Plants
Co-generation & Combined Cycle Plants
Power Peaking Units
Upgrading Existing Plants:with
Cool Convertions
Cool Storage / Handling / Pulverazing
- Cement Plant / Blast Furnace Indirect
Coal Firing Systems
- Metals Production and Processing
Electronic Furnaces
Continuous Casters
Rolling Mills (Steel & Aluminium)
Coating Lines
- Printing
Newspaper production
Periodical Printing
Packaging
- Automotive
Assembly : Paint Application,
Mixing & Storage
Parts : Machining
Heat Treating
- Electronics Operations
Computer Areas
Automated Information
Storage Systems
- Electronics / Computer Production
Wet Benches
Wave Soldering Machines
- Food Processing
- Research Facilities
Test Facilities
Anechoic Chambers
- Shipboard (Marine) Sytems
- Automated Storage and Retrieval Facilities
|
 |
|
 |
|
|
|
| |
|
|
|
Presentation I
Our Products I
Site Map I
Contact
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Ulvi Cemal Erkin Avenue Yýldýz Sanayi Zone 5. Blok No: 62 Ostim / ANKARA
Phone: ( 0312 )
354 61 74 - 354 61 75 - 354 79 94 - 354 79 95
& Phone-Fax: ( 0312 )
354 49 36
www.tam-tup.com
& www.tam-tup.com.tr
|